Case Modding - Page 2

This is the 2nd page of the Case Mod. If you missed the first page, you can see it here. Now lets begin...

UV Light installed and stuck on with velcro
The light switch and the dual inverter, so it will power two tubes
The light switch
This is where I will put the light switch - the drive bay's cover
I measured the light switch and it is almost exactly the same size as the 5p coin. Before drilling, I tested it on a piece of paper. I drew the circle by following the edge of the 5p coin and cut the hole off with a hobby knife
A perfect fit! Now I'm happy
Drawing the edges with a pencil on the drive bay cover
Using my Dremmel, I drilled the holes and then smoothered it out
A bit dodgy circle, but no worries, the light switch will cover it up anyway
As I mentioned earlier, the light switch covered it up very well and it looks clean
Fitted it in the case and job's all done
Tided up the cables inside so the cables won't show up on the case window
The finished job!

Next stage: Put on an Window Applique - Biohazard logo.